Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to use the port based address allocation on my cisco 2960 catalyst switch. So the way it works is we force the dhcp server to use a subscriber id instead of client-id. You then tell it to create this subscriber-id from the interface-name....
I am trying to configure DHCP Server on a Cisco 2960-X switch to achieve port-based address allocation. I would like the IP address assigned to any device connected to that port to be the same every time.
I have used the following guide to achieve th...
That explains why I have been having so much trouble. This has been driving me crazy as I did the process multiple times but it just wont work and then I caught the reason why in dhcp bindings. Here the current version I am using:
Cisco IOS Software,...
The "" are added in the config file. I added the address just like you showed above. Also if you look at the first line in dhcp bindings table and it says the address was assigned automatically thus 0047.6931.2f30.2f was received by the dhcp server a...
Hi, Thanks for your reply. I tried what you suggested but it didn't help. so the problem I am facing is as follows. Here is the results of dhcp binding when plugged into the following ports:
port#interfacereceived SID(hex)expected SID(hex)2Gi1/0/2004...
@PhuongTrinh Hi, I am trying to achieve the same. but I am having trouble where the last byte of the interface name is lost (32). Please advise.
VRF: IP address Client-ID/ Lease expiration Type Hardware address/ User name 192.168.100.1 0047....
