Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I noticed that sh run, wr and some other sh commands are taking forever to execute. After researching I have noticed that my CPU utilization is really high.
Does anyone know how to fix high CPU utilization caused by SSH on 6509-e?
SW-CORE-6509#sh ...
Hello Karsten,
I have a similar issue. Interfaces 1-48 are user facing with the following configuration.
description USER_PORTS switchport access vlan 10 switchport mode access switchport voice vlan 20 logging event link-status srr-queue bandwidth ...
I tried to kick the user with commands below with no luck.
SW-CORE-6509#sh useSW-CORE-6509#sh users Line User Host(s) Idle Location 1 vty 0 ttsit idle 1w6d 10.32.183.136* 2 vty 1 ttsit idle 00:00:00 10.32.180.64
SW-CORE-6509#clear line 0[confirm]y [...
Another strange thing that I have noticed is that the vty session is connected for over a week and I have VTY session timeout enabled.
SW-CORE-6509#sh users Line User Host(s) Idle Location 1 vty 0 ttsit idle 1w6d 2 vty 1 ttsit idle 00:01:47 * 3 vt...
Thanks for the reply.
I think that the SSH session is causing the issue, but I can figure out why. I turned off all debugging and the CPU is still at 100%
SW-CORE-6509#no debug all All possible debugging has been turned off
SW-CORE-6509#sh processes...
