Agreed that forcing the LAN port speed to 100Mb is a bad workaround.The better temporary solution (you may be an expert) is for the WAP toadvertise the capability of 100Mb FDX in autonegotiation.  I believeautonegotiation will then bring the connecti...

Let's hope this works.  From the release notes, it appears I will haveto set the speed setting to 100M mode.  Once I did this, my managedGigabit switch indicated the port is now at 100TX mode.However, the switch also indicated the connection is now H...

I have the same problem with my two WAP4410N connected to my Cisco SRW2024 Gigabit switch.It appears that there would be a time where the PHY's between the WAP and the switch are hung.The lights on the Gigabit switch are constantly flashing.It is unt...