Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a Cisco 1841 serving as a connection between my ISP and my Firewall (non Cisco).I seem to be having performance issues with my traffic going through the Router.HTTP (web browsing) is fine andI get my download rate as I would expect for ...
Simple question here folks,I have a SR520 router with the ADSL WAN built in.I am looking to ignore the ADSL port and utilise the 4 FA ports to route between two networks.Can I configure the ports on the switch part of the router to become Layer 3 and...
Hi all,Apologies for a noob type question here but I am hoping to save myself a junk of money:I currently have a Cisco SR520-ADSL router in place utilising my current ADSL2+ Broadband connection.The router is using a /29 Public address range on the A...
Hi Guys,Need your expertise on this one. I have a Secure Router 520 with the ADSL of POTS WAN link for my company Head Office Broadband connection.I have got it all working with one live IP address using a Loopback0 Interface.Anyway, my issue is that...
Hi People,Basically I need a router to 'pass through' traffic without it changing the ip subnet. I have live IP addresses behind the router, attached to fa0, and they have the same ip range/subnet as the routers atm0 interface (I purchased a Non-NAT ...
Thanks for the reply.Just to clarify my firewall is inside the Cisco 1841.ISP << 1841 << Firewall << LANAll I want the 1841 to do it route from one to the other, nothing else.
Hi Andy,I have looked into upgrading a LAN port on the SR520 but it can't be done. They are L2 only. I looked into switchport and SVI but neither could be properly achieved on my current hardware.I have gone for a reconditioned 1841 for the solution....
Thanks for the responses chaps,I need to put the IP address actually on the interface so Layer 2 Vlans won't be enough.Having looked at the "no switchport" command within one of my fa interfaces I do get a submenu, but still note sure I can get a L3 ...
