Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
See if this helps you. The upgrades have to be incremental and will have two or more steps. For 8.0, you can move to first 8.2 and for others, use the table below. http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-f...
I remember that being there by design. Fail back or Preempt was not supported in case of Redundant interfaces and is actually not a good idea in terms of stability. You dont want the interface failover to happen again when the active interface comes ...
Hi.Have you enabled ACL optimization. If not, have a look at this and enable ithttp://www.cisco.com/en/US/docs/security/fwsm/fwsm40/configuration/guide/traffc_f.html#wp1068726ThanksZubair-Pls rate if post was useful-
Yes, it is possible to have both on the same router. For the remote access VPN , you need to use a dynamic crypto map.crypto dynamic-map dynmap 10 set transform-set 3des-shacrypto map myvpn 10 ipsec-isakmp dynamic dynmapThanksZubair
