Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have two Cisco Catalyst 2950 switches and two 2620XM routers. I need to set up a lap to practice on my CCNA exam. The routers don't have Network Module, WIC. What else do I need and how a lap is set up? I'll appreciate your responses.
Thanks Reza for your advice.Michael, thank you very much for your time to answer me and your very helpful infos. I am sure when I find time to mess with my lab trying to "have a lot of fun" as what you have done, I will run into a lot of obstacles. ...
Thanks ganeshh.iyer for replying. Here is a brief of my existing network:Comcast Cable --->Trendnet Router(Consumer based) ---> A hub. The TrendNet has an internal IP of 192.168.1.1 with DHCP enabled. Thanks again.
Thanks Reza for your quick reply. Are all the cables just straight through ones? I want to connect this lap to my existing LAN and have internet connection, how do I do that? Thanks.
