Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI all,I have a Network Diagram as below. I configure firewall as active/standby transparent mode (attached is firewall configuration file).But when I use command "Sh Failover" the result show as below:------------------------------------Failover OnF...
Hi All,When I try to open 1 port by "no shutdown" command, all another port is down in few second and automatic up after that.Anyone know why I got this issue?Thank you so much.
Hi Alls, I have a question when I try to connect 2 group of redundancy Firewall as picture below. I never try before. Is it possible to connect like picture and what I need to configure in both side? Thanks in advance, and have a very nice day!
the last topology as picture belowthe router can configure as the switch with "switchport access vlan 200" command. I just set IP address for vlan 200 and route it on static router table.
HI all,I already found out the solution.1. We need create separeate port channels for 4 cable as below link:https://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/interface_start.html2. We need to use VLAN or I...
anybody can help me this case, anything need to warning at router side. For now, I configure portchannel with lacp protocol. Any idea to fix this case?
