Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
You may also want to test from the perspective of the switch you plugged the MARS into. Verify MAC-ADDRESS-TABLES for VLAN MARS assigned to along with IP ARP tables - possible dup IP.
Depending on the # of elements (end-points) you need to monitor, the SolarWinds Orion NMS suite is very good and provides advanced notification/alerting services along with a number of great add-ons.http://www.solarwinds.net
power redundancy-mode To set the power-supply redundancy mode, use the power redundancy-mode command. power redundancy-mode {combined | redundant} Syntax Description combined Specifies no redundancy (combine power-supply outputs). redundant Specif...
You need to adjust your NAT (inside) statement according to the allowed IP addresses ranges.Attached is an example of a PIX with 3 Internal Networks that you may reference.Hope that this is helpful.Scott