Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The link below suggests there is a feature on 6500's to detect unicast flooding & syslog when it occurs: http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00801d0808.shtml#detectI have various 6500's running code much high...
Never tried it on a 3750 but this works well on a 6500 - setup a rspan session locally, apply an vlan acl (vacl) to the rspan destination vlan - then you have very granular control over the traffic sent to the destination port. This link describes th...
ok many thanks Edison - I was hoping to use this feature as a gauge to measure the level of unicast flooding on a vlan. Without this feature the only way I can think of to achieve this is to use a sniffer.
