Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, All. My customer has Cisco MDS 9506. It was connected 4 HP LTO(MSL) ports.There were disconnected a link of signal to HP LTO, and that was reconnected a link after several times(30-60mins).Then MSL tape drives become offline and have to manually ...
Hello!I need...... configuration best practice guide for UCS C460 M2.1. what is the memory configuration of max memory clock? ex) 16GB pair kit, 32DIMM slots -> Total size ; 512GB, clock speed : 1066Mhz?2. When install of all memory, what's the mem...
it's working connections after LTO reboot, but it's become offline when to proceed a backup after few hours again.It have repeatedly shown same situation.In 1-2days, we'll run a task is changing from 8Gb and ARBFF to 4Gb and idle.
To Walter.HP LTO seems like N port type.I configured F mode on MDS SAN. * show fcns databaseFCID TYPE PWWN (VENDOR) FC4-TYPE:FEATURE--------------------------------------------------------------------------0xb00360 ...
Dear Walter, thanks for your reply. 1. You mean that LTO port will have to change a port type as N port, right? and isn't HP LTO ports N port? Could the LTO controller change a port type as N port?2. So, CISCO MDS is supported FL(fabric loop) a...