I need to activate IP SLA on my 6509 switch. I ran "sh ip sla?" and I did not see IP SLA on my switch. Problem is I went to download the latest IOS that has IP SLA and figured I would check my current IOS against the latest and according to the Cisco...

I am familiar with how the encapsulation process works but I cannot find any good information on how encapsulation works when turning on Jumbo frames. Cisco's 3750 documentation referees to Jumbo Frames. Now is Cisco just confusing me or are they act...

I have a 3750 that is only allowing two ip addresses to pass through a layer 3 port. I need to allow the host to connect to the DHCP server on the other side of the port but have run into problems setting up the access list to allow bootps and bootpc...