Hi I bought my first Cisco router for learning purposes. I followed blogs regarding setting up dhcp or static on WAN port but im having error
% IP addresses may not be configured on L2 links.
I already entered the #wan mode ethernet .
tried setting...
when doing ipconfig /release and /renew it does obtain a bit faster compared to disabling and enabling the network interface.
regarding the vty, i have added these lines and now i can access ssh on the LAN side. i think this is correct as i only w...
i just remove the ip helper address line.. and to my surprise I was able to obtain IP Address.. waaaahh I think it needs time just to obtain an ip address.. is this normal for cisco? thank you Richard for pointing it out and I've learned a lot.. have...
Hi Richard, I think I have properly configured it on its basic configuration as of now. I'm wondering if its normal for this model to have a maximum throughput of 200Mbps while my ISP can achieve 1000Mbps? This is my working configuration...
Curren...
Hello good day, I followed your config with few addon while slowly configuring in CLI, I have internet in client side but i have to manually input the IP Address. Can you please guide me again regarding DHCP so i can set my pc in auto obtain? please ...
Hello Georg,
I was confused by the ports available and from the tutorial i followed, just known that there are several models with different number of ports in Cisco 800 Series. My WAN port is solve and i have another problem is it okay to add anot...
