Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We are trying to setup a ACE 4710 FT solution with following charateristics.Standby ACE should takeover in case of primary ACE failure due to any of: completly lost (power failure), single interface down, reboot, lower tracking priority.The stand...
Pablo, Thanks, that's a good document; it got us on the right track. Now the ACE behaves the way we want. Actually some extra access-lists is needed, we put them in the switches....This is needed to block ICMP echo from ACE, since the probe will cont...
Pablo, Understood, but at the same time you limit the failover detection to only be reachabillity on the crossover between the ACE boxes. From Chapter 6 in the ACE Configuration manual (Configuring Redundant ACE Appliances): You must configure preemp...
