Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning,We are currently running our CSM 3.3.1 on a Server 2003 box. Support wise we knew we had to get CSM onto a new server 2008 64bit box. Our problem is that we have built a new server and installed CSM 4.3 on it but we need the database f...
Afternoon all.We have a remote site that has an address of 172.20.224.0/20 which connects back to a core firewall to the network 192.168.168.0/24 through a private circut. Both firewalls are asa 5505's and this works fine. We wanted to put a backup...
Afternoon all,We have a cisco 800 in a remote site which we wanted to use for a site to site vpn. I thought this would be simple as i have setup ipsec and ssl vpn's before on ASA's without any issues. This has gone so wrong that i think its best ju...
Evening all,Hoping that someboy can see the error of my ways. It seems very like the problem that i read here: https://supportforums.cisco.com/thread/2016300We have a cisco 800 in a remote site which we wanted to use for a site to site vpn. Went th...
Evening all,Here is the current problem that we are having on a few sites. Our set up is that an interface on the ASA is hard-coded as 10 Full. The port on the cisco 2960 is also configured as 10 full. We are getting really slow traffic through th...
A bit more info.....i got the log file working and now we are getting the following message when it fails:No Database files are available for the installed applications;nothing to backup
So i just have to change the routing on the core ASA for that route. What is the easiest way to do this? We have always used staic routes on all our asa\pix devices up till just now. Thanks in advance.
Jennifer, Thanks for that. I was wondering how it would route that traffic since there was a static route on the core asa forcing it to a specific interface. So is the answer really setting up the cisco 800 as an Easy VPN Remote back to the ASA. ...
Jennifer,Please find the requested info below:Password: *******secure-access# sh run int!interface Vlan1nameif insidesecurity-level 100ip address 192.168.168.1 255.255.255.0!interface Vlan2nameif outsidesecurity-level 0pppoe client vpdn group BTip ad...
marvin,Thanks for the reply. I was actually using these tools to try and configure it before without any success. I have ran through the wizards again. How can i make this a constant vpn session and not one that is intiated through traffic?
