Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.We are in the process of moving a bunch of access points from an old supplier to us as a new supplier.The old supplier does have a WLC which "holds" all of the access points.I set up a new 9800 WLC, and tried to move one of the access points to...
I am not sure why none of these commands work. But I am in enable mode.I got the commands to work from my controller, but not with ssh into the ap.And I dont have access to the previous suppliers controller, so it seems like the only method is to phy...
Hello and thank you for the tip.i did this on One of the ap and moved it to the New subnet.i am getting a ssl error on the ap.currently on phone so I dont have the specific error but the AP does not want to join because of the ssl error.it looks like...
Hello again Flavio.Thank you for your help so far.I figured out on my controller I could run the clear ap config <ap-name> keep-ip-config. That command rebooted the ap and cleared the config.Is the access point configured in a special way since I can...
I am not experienced with either Cisco AP or WLC, but learning by the day.What is the command to show mode?The clear capwap private command is not recognized.
