Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone, i am currently deploying cisco ISE and already facing a few problems. The cisco ise and authenticator switch are in the same VLAN but somehow i cant see the switch on the ISE GUI. Same with the connected endpoints on the switch. I´m ...
Dear cisco community, i am recently trying to deploy cisco ISE following the guide for wired access control. For this project i choose to use a cisco 2960S-24TD-L switch with the 152-2.E9.bin, because on a cisco website for ise i saw that it was full...
Hello everyone, in our company i would like to implement ciscoISE for the wired access control with certificate based authentication. My goal in the end is, that all clients who don't have the certificate of our CiscoISE Server only get a default VLA...
Hi Rob, i enabled dot1x globally and then restarted the ise-services. The device still does not show up and authentications are not being sent to the ise server. If i do show aaa servers i get this:SWCGN1ACST006#sh aaa serversRADIUS: id 1, priority 1...
Oh i actually looked into the 2960-S switch config which i had configured before the 2960-X and there i used the command dot1x system-auth-control, but it was also not visible in the gui. I think there is something else which i have not discovered ye...
Oh ok my bad, when im at office again i will enable it globally and then look again if it solves the problem. Thank you for taking time to help me out, hopefully it will work.
Oh yea, i think that i just enabled it for the 12 port range that i defined. I didn´t need all the 24ports, do you think it would make a difference if i enable dot1x globally? Because it should be a very easy configuration for the device to show up i...
