Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have read the discussions that came up reg. this bug.We run 2 clusters of Cisco ACE 4710 - that is 4 devices - with software rel. A4(2.1). Uptime is 741 days and there's problems synchronizing between members, as well as the well known repor...
Hi,On my corporate wireless net, there is an SSID to allow guests to reach the Internet. They receive a voucher with 1-day valid credentials and are asked to open a browser, which is redirected to a login page https://1.1.1.1/login.html. The controll...
Hi,Is it possible to send input via line console 0?At default, it is an output only port. It works fine but I want to configure by terminal.RegsOleTCCopenhagen
Well, I chanced and reloaded the standby unit. Unfortunately it lost it's configuration, including keys and certificates.The cure was to upgrade software on both devices to 4_2.3 software and then synchronize from the active configuration.The keys a...
Thank You for Your answer, Ajay.I checked and the startup config is similar to the running config in all contexts. I will probably be allowed to do the reload tomorrow. Else, later.Either way I will update the thread with the outcome.RegardsOle
I actually used George's blog as guide, when the project started and I made it all the way except for the reload of controllers after typing ind the fqdn in the VIP. So another restart - and it worked perfectly. Hehe....erhmm.Thank You for all Your h...
Hi again,I hit the wrong button there and gave You the credits for correct answer. You will probably deserve it anyway, if the solution is as simple as You have lined out.I can restart the controllers in the evening, test and do a follow up message ...
