Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Andrew,In the Active Directory configuration, make sure you have entered the full domain name. Along with this login to the ACS through SSH and make sure that the timezone and the time on the ACS and the AD is the same and make sure the ntp server...
Hi Jon,Could you let us know the exact version of the ACS? If it's the ACS 4.1.1.23, then you would have to apply the latest patch of ACS as there is a bug in ACS 4.1.1.23 in which command accounting does not work.Here is the information about the bu...
Hi,Could you provide the aaa config part from the device? Along with this, please mention the protocol which you are using (Radius/Tacacs)?If you are using Tacacs, make sure under the group setup, you have checked "shell" and under the privilege leve...
Hi,You can go to http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_solution_engine/4.2/installation/guide/remote_agent/rawi.html and check the windows authentication configuration. These steps have to be followed so that...
Hi,If you would order the ACS appliance, you would get recovery disks with it which would have the ACS for Solution Engine.You would just need to use that disk, it would first install the base Operating System and then the ACS software.You would not ...
