Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco ASA 5505 as im trying to set up with the following scenario: I need eth0/0 - Outside that get its IP from a DCHP withing my ISP’s netThen I need eth0/3 - Inside that run DHCP 192.168.1.100 – 192.168.1.250 with normal Internet access an...
I bought a Cisco 877 router with the ADSL-POT interface (not WAN port) and have done the Wizard with all the correct settings... However I cannot seem to get the PPPOE thing to connect. The interface is up but on the Overview its Down... Any suggesti...
Okei, i used the interface eth0/x and i now have managed to get inside, outside and DMZ interfaces to work. I've got normal internet access from both inside and DMZ. Now i need to make the rules for the port forwarding on the DMZ interface. Should i ...
Thank you very much Federico.Just one more question, the interface fas1 command? this i am unfamiliar with, I thought it should be interface eth0/x. Can u explain this command for me?
The ASA has a security plus license so this isnt the issue. The issue is that i really aint into the ASA quite yet. Im concentrating on swithes for now so i need help to set up the ASA. Dunno where else to turn...
Now i bought another Cisco router (851) and still have the same problem, now got two Cisco ADSL routers that cant connect to the ADSL lines...Can I set up the old Speedtouch 546i modems in bridged mode and use the Cisco 851 or 877 routers to connect ...
