Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a CISCO 2811 Router I have two ports configured.Fe 0/0 is 192.168.1.1Fe 0/1 is 192.168.0.9 Fe 0/1 is jumpered into a 9 port switch card (0/1/0) HWIC in the router. I have a DHCP server sitting off port 0/1/1 on sw card set to 192.168.0.1. (DHC...
Ken - thanks for hanging with me on this one ..HWIC 9eswWhen I try, I cannot configure an address to the card - returns error 'unable to assign an address to this Layer2 ..'
Ken - thanks for the post.fe 0/1 is connected via a jumper into the first slot on sw (0/1/0). The idea is to exend the 0.x network into the switch card for simplicity. From there, I can hang off DHCP (i.e. laptops) to obtain thier IP from the DHCP se...
