Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would suggest to check the connectivity (faulty ethernet cable) (routing if not on same network) it has happened to me before, or some local ethernet errors that might exist. I am assuming though that the incoming mails are delivered on time from t...
I am not sure if you are sending mails to yahoo, you should be worrying about smtproutes as it handles incoming mails (destined for your internal domains). I see you also removed the sending IP so I am assuming its a public Ip address maybe. Normally...
I am not sure if you can use ldap to verify users, but I know you can enable sender verification on your $RELAYED mail flow policy. This will check for you if the mail from address is from a i) valid domain ii) domain is resolvable and iii) mailforme...
you can verify if mails are flowing via the comandlinebox1>statusThis will show you messages received since uptime (since reboot)alternatively you can just type:box1>tail mail_logsThis will show you messages being processed, the logs just runs up the...
Hi thereWhen you disconnect a machine from the cluster it does not lose configuration. It will carry on processing mails even when performing the upgrade. After upgrade is done and it needs to reboot, will it not process mails until it completely res...
