Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently replaced a WIC-1T and Adtran DSU with a VWIC2-2MFT-T1/E1 at both ends of a point to point T1. The T1 came up immediately, but the second port (connected to PBX) will not come up. The phone guy says that since he shows a red alarm on both...
Also, the PBX timing options are Loop, Local, or External. It is set to Loop. If I understand it correctly, the PBX provides clocking on one pair, then receives it back on the other pair, so it can never get out of sync with itself. I configured m...
Changing the cable at site A immediately got rid of all alarms and sh connection showed UP.However, the line protocol on Serial0/0/0:0 went down after changing the cable on T1 0/0/1. There are still no alarms, but I cannot pass data traffic. We sen...
It sounds like the PC and PIX are configured correctly. Does the outside router have a route to the 192.168.1.0 network?Also, you can try logging on the PIX and/or router to see if the traffic is being dropped somewhere.HTH,Matt
