Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using packet tracer. I have a Router, Switch & 4 PC's. When I go into the PC's Ip configuration & enable DHCP I get the "DHCP failed. APIPA being used" error. What am I missing or doing wrong?I used the following for configuration on R1: (on...
So, this was for CCNA V7 Lab 10.3.1.2 Packet Tracer-Skills Integration Challenge I needed to add the vlans to S1 and after that the DHCP for the PC's worked.
S2#show interfaces trunkPort Mode Encapsulation Status Native vlanFa0/1 on 802.1q trunking 1Fa0/2 on 802.1q trunking 1Fa0/3 on 802.1q trunking 1Fa0/4 on 802.1q trunking 1 Port Vlans allowed on trunkFa0/1 1-1005Fa0/2 1-1005Fa0/3 1-1005Fa0/4 1-1005 Por...
R1(config)#interface gig 0/0R1(config-if)#no shutR1(config-if)#interface gig 0/1R1(config-if)#ip address dhcpR1(config-if)#no shutR1(config-if)#%LINK-5-CHANGED: Interface GigabitEthernet0/1, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on In...
