Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Visio stencil needed for the part C-SM-16P4M2X. We've checked the stencils page linked previously with no luck.Please advise at your earliest convenience as we are presently planning/diagraming for upgrades this year, hoping to stick with Cisco movin...
Esteemed, bumping this thread as we are in dire need of a stencil for the sixteen-port NIM module for the 8000 series routers.Part number: C-SM-16P4M2X
Had this same issue recently. Check out the DIMM module closest to the F0 (Forwarding Processor). run : show platform, and check if the Forwarding plane processor (F0) is stuck showing "booting" status. Might just be a case of a bad DIMM module or pl...