Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hallo , i have a question if my configuration for dual HSRP is correct, and if the HSRP failover works with natthank youROUTER 1========..track 10 interface GigabitEthernet0/1 line-protocoltrack 20 interface GigabitEthernet0/0 line-protocol!interface...
It is possible to have two HSRP on two interfaces on two routers ?ROUTER 1track 1 interface GigabitEthernet0/1 line-protocol!interface GigabitEthernet0/0ip address 172.16.1.11 255.255.0.0ip nat insideip virtual-reassemblyduplex autospeed autostandby ...
hello , i have two cisco 2900 with two Ethernet (internal and public) . the Eth0 on both router go to my internal network with Standby configuration . the Eth1 on both router go to two switch , where we are behind two routers xxx1 ...
hallo i have a cisco 1700 and i have replace it with two 2800 with two LANi intend connect the first lan of cisco 2800-A to my network (172.20.1.x) and the second lan to another network-ALFA (10.10.10.x)idem for second cisco 2800-B to my network and ...
ok, sorry for my english. I need to have two routers with two virtual IP failover on both networks. Using the GE because they are connected to the switch, both in my network in that set. so I wanted to know if I should track both or not. for the sec...
ok excuse me for my englishnow i have a cisco 1700 but i have intention to change it with two firewall (or router) for have high reliabilitywhat i can replace it with ??
hi rahulmy problem is to connect my network to network-ALFA without to use a firewall appliance (for the high price of buyng)currently i use one cisco 1700 with eth0 and eth1 fot to nating and routing with access-list for blocking protocolsi need to ...
