Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a few hung DS0s (up for over 1 day) on my E&M trunks to the PBX which causes some user issues with UMAIL. Is there any way to clear individual DS0s when you are only using a single DS0 group on your T1 controller?Hardware 3640 T1/PRI IOS 12.2(...
"Yesterday I install a new 5.0.2 image on IDSM-2 module and works fine. Then I try to upgrade the maintenance partition to version 3."Version 3 is not compatable with the IDSM-2. Version 3.1(2) Cat6k Maintenance Partition Image for the Wireless LAN S...
Thanks, that is what I thought. Inheritance stinks, a single DS0 group is not my preference. I have been busing out the call and shutting the entire voice port down to correct this in the past. 12.2(13)T1 sounds like it might be in the future.Thanks ...
