Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a MX75 and VMX in Azure with S2S VPN.I have a number of VMs in Azure that I need to expose certain ports to the internet.Can I do this through my VMX whilst in Passthrough/VPN Concentrator Mode?Thanks,
Hi,In Azure, I have my vmx-subnet 10.64.4.0/24 and my internal subnet 10.64.1.0/24The vmx is on 10.64.4.4.What should the 'Single LAN' Interface Address be? I don't understand how I can set an interface address inside an Azure subnet. Thanks,
Please can I have an additional user for my Anyconnect VPN so I can test voice calling end to end? my sandbox id is 603b5ef6-db9c-41a4-a322-b0321a342ac1 thanks!
Thanks all. I was hoping the vMX would be an edge device. However given it isn't, i have just deployed a NAT gateway and load balancer in my vnet. The vMX is just dealing with routed traffic.What is the logic behind the vMX not being able to be an ed...
Thanks, I had followed a couple of tutorials and they all showed that you should add local networks here, but didn't require an interface address. This makes sense as I want to explicitly state which networks are advertised through the VPN.however I ...
