Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Long story short I have some older aps that can't go past 7.0 code. While I'm waiting for those to be refreshed I need to provide those areas with guest access. I've attempted to set up LWA with the external authentication page coming from ISE, and t...
Except the same radius configuration authenticates my production wlan. Somethings happening with the username redirect from ise's portal to that wlc in my opinion. My next step is to grab a packet capture to see what's happening
Yea I'm using cwa for the code that can run it but the 7.0 wlc is being troublesome. I duplicated the same setup on another wlc with 7.0 code and it worked, so I just have to figure out what's up with this particular one.
