Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,
I have an issue with a customer's AP. It is a newly refreshed site with a mix of 9300L-24P and 9200CX-12P switches. At the moment, 3 of their APs are inconsistently powering up. These are brand new 9124AXE APs, the switches are brand new too...
Just to update on this..was a very long time ago, but it was a bug with the On-Prem server. After updating it, the Nexus devices registered straight away.
I know this is a couple of months late. I ran into this issue last night also using the 'show ip bgp vpnv4 vrf <vrf-name> command.
It seems the parser is not ready to pickup the route distinguisher line in the output or the way they have built the pa...
Hi,
Did you ever get this working? We have a lot of devices for our customer which work with the On-Prem, however I cannot seem to get the Nexus devices working. So frustrating! I have a TAC case open, but it's the typical scenario going around in ci...
Tested with 17.9.1 and 17.12.1 with same results.
Not at the moment, but at the time of the wireless migration for the customer we had one of their old Cisco 1240APs on port 9 and the new 9124 was on port 12. At the moment they have a Polycom confere...
In a similar issue with a 9200CX-12P at the same site, when we connect the 9124XE AP to the 9200CX it has the same issue. Switch doesn't detect the AP and it won't power on. However, when I take the same 9300L we were testing with as discussed above,...
