About djhender

djhender · 01-24-2003

Our network is segmented by Class C IP regions. We previously had a seperate 2600 series router for each of these regions. We purchased a 4000 series router and set it up to route IPX on all the vlans. We are able to connect to both our Novell serv...

djhender · 01-31-2003

We have Supervisor Engine III installed which combines the switch and rounting functions. The servers reside in the 192.68.223 region and I am trying to boot to a server from the 198.30.44 region. Here is a sanitized copy of our config file:!versio...

djhender · 01-30-2003

Yes we have ip helper addresses set up.

djhender · 01-30-2003

We disabled the Spanning Tree function and it didn't help.

djhender · 01-29-2003

I sent the configuration files from both the 2600 and 4006 to you. With the 2600 we were able to use a bridge group to bridge all protocols. With the 4006 when we tried this it returned the "Unrecognizable Command" error.Thanks.Dave

djhender · 01-28-2003

I use a product from Altiris called Rapid Deploy. This product comes with a network boot disk creator. It has you gather the necessary NIC and DOS files and then uses a wizard to create the disk. Below is a copy of the Autoexec.bat and Startnet.ba...

Member Since	‎01-24-2003 01:50 PM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	7

User Statistics

User Activity

Can't connect to Win 2000 Domain Controller thru 4006 router via Boot Disk

Re: Can't connect to Win 2000 Domain Controller thru 4006 router

Re: Can't connect to Win 2000 Domain Controller thru 4006 router

Re: Can't connect to Win 2000 Domain Controller thru 4006 router

Re: Can't connect to Win 2000 Domain Controller thru 4006 router

Re: Can't connect to Win 2000 Domain Controller thru 4006 router