Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a /24 block of public IP addresses that I would like to split between two sites. This block is routed to site MAIN. I would like to send a portion of that block to a site REMOTE over a VPN tunnel (the Internet connection at REMOTE has a single...
Yes that is what I expected. but it does not work. When you enter a static route, you are only offered the choice to send it to the LAN or WAN1 interface. The tunnel is not a choice. It works from the local LAN to the REMOTE LAN, but traffic receiv...
Where is the VPN policy defined? All I see is the ability to define the local and remote networks on both ends of the tunnel. But nothing defining the source and destination of the traffic itself. That would be perfect. But I do not see that availa...
The AIR-BR342 has the Utility built into the console/telnet interface. In the menus go to diagnostics/linktests/strength. A very nice continuously updating bar graph is displayed. Use an ANSI color terminal emulator for best results.
