Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure a 2811 so that it can bothuse overloaded NAT inside to connect to the outside world via an ISP, and can also accept incoming traffic which I need to NAT the source address to ensure traffic goes via this router - during a cha...
I wonder if anyone can assist:We are changing ISP, and for a short period have two lines, each with a 2811. We use NAT translating a number of IP addresses onto one internally addressed web server. Unfortunatly I can't transition all the sites to t...
Hi,Thanks for that.I tried removing the ip nat inside/outside and reentering the NAT configurations, but lost connectivity (via the ip nat inside source list 1 pool ovrld overload) from inside to outside.I suspect I am missing something about how I s...
Thanks, that looks very helpful, though I'm not entirely sure I follow the bit about configuring NAT on a virtual interface. But seems like that is what I should invesigate.RegardsTim
