Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,My name is Sandeep and I am facing very weird problem with my 2960 switch. I have configured my Juniper firewall interface with the ip 10.11.89.5/24 and connected it to 2960 switch port. The default VLAN created on switch is carrying ip address 10...
Hi Antonio,No need to configure that port as a trunk port and i tried that option as well. Also I didnt configure VLAN on Juniper. It should work in access mode as it is L3.
Hi sajid,I tried to configure the suggested command but i am not getting that option. the version on the switch is Version 12.2(35)SE5. and it only allowed me to choose any from the allowed, native and pruning option.
Hi Syed,the result is showing up but there is no firewall rule need to configure for it.The same setup i have done in my Mumbai office but i didnt face this issue but i used Nortel Baystack switch for that.
Hi Antonio,Thanks for your prompt reply please find enclosed the config for switch and my firewall is connected to port fa 0/1. the status of the port is link up and connected.Switch#sh runBuilding configuration...Current configuration : 1301 bytes!v...
