Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i would like to know, whether it is possible, to run 2x2GB (4GB in total) in an ASA5520?The installation guide shows 4 DIMM-Slots. So actually it should work to run an ASA with4Gig of RAM, shouldn't it?The Release Notes of the 8.3 firmware release...
Hi everyone,we've got a problem regarding the SIP Inspection Protocol Helper on the FWSM (Firmware 4.0(10)).When initiating phone calls via VoIP(SIP), users reported a delay of about 2 secs before hearing the dial tone.Looking at the firewall logfile...
Hello,we've got a problem with split tunneling and Anyconnect clients. Basically, our policy for remote access users is as follows: local LAN traffic should be allowed directly (eg. local printing), everything else should go through the tunnel. This ...
Hi,the dead peer detection with IPsec-Clients works very well on our ASA 5520. In contrary to this, DPD does not work when Anyconnect-Clients lose their SSL-VPN connection (e.g. when their LAN cable is pulled off). Although we set the appropriate set...
Hi,when i try to connect with an older Anyconnect Linux client to our ASA, then the client automatically updates and logs in. Thats perfect so far.But when i do not use the Anyconnect-GUI (vpnui) and try to connect on the console/cli instead without ...
Hi,problem solved. I did the following steps:1. upload PKG-files (XML-profiles etc.) to the flash of the standby ASA2. execute "write standby" on the active unit ("write memory" didn't work for me!)3. execute "write memory" on the active unit to copy...
Hi Jason,thanks for the quick answer!I will then upload the PKG-Files and XML-Profiles to the secondary unit.But it remains the certificate problem. When i make a "diff" between the config of the primary unit and the secondary unit, the certificate b...
Hi,same problem here!I can see that whole certificate block in the primary ASA's running-config, but there's nothing replicated to the standy unit config.It even gets worse: when i trigger a failover to the standby unit, the certificate is not there,...
Of course i tried connecting from Win XP Clients and from Vista Clients as well using their built-in VPN tool. Neither the XP machines, nor the Vista machines were able to connect correctly to the Concentrator. In both cases i just got an error, alth...
Thanks.I also tried Expect and it works well.Nevertheless, it would be a nice feature for the next release, to allow rsh/rcp since it works well on Cat6500 too.Regards,Marco
