Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got a remote site with an 871 router. it is connected via an ipsec tunnel back to my head end VPN 3030 concentrator. all traffic is sent over the tunnel. i would like to break off traffic that is not destined for the head-end LAN and point it ...
i'm going to be replacing my PIX's & Concentrator soon. Since they are separate boxes, they have separate public IP's. when i consolidate them down to an ASA 5520, should i use multiple interfaces for the public side or can i get away with just usin...
I've got two 3845's, each with a DS-3, carrying two subnets on them for my border routers. Some simple traffic shaping was set on the two Gig interfaces to allow for bandwidth limiting. I.E.- i wanted to be able to put a cap on the amount of BW eac...
I have a VPN Concentrator 3030, which my remote users connect to from home. The idle timeout is set to 30 minutes, however, I do not see anyone disconnected due to lack of activity, even if they are connected for over 24 hours. I assume that they a...
I am trying to build remote client VPN's on a PIX running 6.3.3 code. The client get's an address, but no gateway, and is not able to get around the inside interface network on the PIX. Is this a NAT issue, a gateway issue, or a routing issue?
thanks for your help.both the concentrator and the pix's are going end of life. the concentrator has been failing recently.i "assumed" that a scenario with dual ASA's in failover mode, along with the using the IPS module (in order ot get rid of my I...
