Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,The problem I have with the below configuration is:Client: 10.10.40.4 can't not go out ISP B because it is static NAT to the secondary subnet ip of ISP B.If I static NAT 10.10.40.4 to the primary subnet ip of ISP B such as 10.10.20.4, it wi...
Hi, I’m trying to configure a basic PIX firewall configuration with No NAT. The problems are: I can not ping from the inside network: 192.168.1.0/24 to the outside interface: 10.10.10.10 or the device on the outside network 10.10.10.0/24 I can not pi...
Hi NT,I tried this configuration but still not work.If I nat 10.10.40.4 to an ip 10.10.30.3 of the secondary subnet, it not workIf I nat 10.10.40.4 to an ip 10.10.20.3 of the primary subnet, it works.Any idea? Thanks,Vu
Hi NT,Thanks for reply. I ran out of IP to use in ISP B network, so I requested more IP. They sent me a block of new ips and configured to their router as the secondary set. The interface has two ip and I can ping both of them from inside of my route...
