Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,The Last Any-Any block is not working as expected. When we set action of this rule to Allow then all the user created policies work fines (Created above this rule) & if we set the action to deny then all the traffic gets blocked. Any suggesti...
We are observing intermediate packet drops in traffic where the cisco C9300-24T is connected to fortigate firewall. We are using copper port on switch side and sfp-RJ45 at fortigate side. Need help to resolve this issue. Thanks.
BFL_DC_NEW_DMZ_SW#sh int GigabitEthernet1/0/21GigabitEthernet1/0/21 is up, line protocol is up (connected)Hardware is Gigabit Ethernet, address is 00b1.e305.1315 (bia 00b1.e305.1315)Description: NEW_DMZ_SW to FGT_PRI_FW_PORT-05MTU 1500 bytes, BW 1000...
Hi Georg,After a long time, I was checking the issue from the fortigate side but not found any issue yet.Can you please any command or solution from the switch side. So, I can verify that switch is dropping the packets or not.Should we use SPAN or an...
Hi Georg, We have testing the ICMP traffic by bypassing the switch and directly connected two laptops to the firewall but we didn't observed any packet drops. But If we connect the switch then we observed packet drops. Do we need to check rate limit ...
