About Mykematt

Mykematt · 07-22-2022

Hi all,On a multilayer switch, my VLANs are down. I have read other posts about what to do but I can't seem to figure it out. I have created VLANs for the interface VLANs but that didn't work. I have also reinstalled packet tracer as I read that cisc...

Mykematt · 06-24-2022

I am new to cisco and learning networking. But the different vlans I created can't communicate with each other, and I can't seem to find the problem. What should I post here inorder to enable you to assist in locating the problem?

Mykematt · 07-23-2022

Thank you, it worked. But can you please tell me what I'm doing wrong. These two typologies can't communicate. I can't ping the computers on one from the other. Thank you.

Mykematt · 06-24-2022

Thank you very much. I really appreciate it.

Mykematt · 06-24-2022

Hi Flavio, and thanks for your assistance. However, can you walk me through your process, so I can learn? First, I did try to perform the IP route on the multilayer switch, but it tells me that the hop address is an IP on the router itself. So, how d...

Mykematt · 06-24-2022

Thanks, but the configuration for the left network was intentional. I wanted to learn how to configure in both access and trunk modes. So, on the one on the left, I used the access mode, hence the two wires. For the one on the right, I used the trunk...

Mykematt · 06-24-2022

Okay, I have a 2960-24TT Switch, and I think it is layer 3, although I am unsure. The reason I think so, is that I have two networks on my workstation, the first works fine, i.e., its vlans can communicate with one another, and the switch I used is a...

Member Since	‎06-24-2022 07:56 AM
Date Last Visited	‎08-19-2022 12:46 AM
Posts	7

User Statistics

User Activity

VLAN protocol down

Segmentation wrongly done

Re: VLAN protocol down

Re: Segmentation wrongly done

Re: Segmentation wrongly done

Re: Segmentation wrongly done

Re: Segmentation wrongly done