Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
I feel like one needs a degree to navigate the new IOS-XE licensing, it just should not be this hard.
I have recently purchased a throughput license for an ISR4321 Router, which boost WAN throughput from 50Mbps to 100Mbps. This was due to up...
HI All,
This is my first post here, after much lurking, and I am hoping this is the right place to come for some assistance with this painful NAT issue I am having. I would consider myself to be fairly experienced with these sorts of network, and ha...
HI All,
This is my first post here, after much lurking, and I am hoping this is the right place to come for some assistance with this painful NAT issue I am having. I would consider myself to be fairly experienced with these sorts of network, and ha...
Hi Georg,
Thanks very much for getting back to me, you hit the nail on the head. I've now got a lovely 100mb throughput.
I had a feeling there was a command I was missing somewhere that would put the router into high bandwidth mode, but I saw no men...
Hi Tony,
I ended up sending the unit back to the supplier and had the whole thing replaced. The new unit's NIM-VAB-A card was DOA, and by this stage I was at my wits end after waiting 2 months to get it all replaced. I have since sent the dead NIM-VA...
For those following this topic:
The issue was finally resolved by doing an RMA on the ISR4321 & NIM-VAB-A, and was replaced after a lengthy wait with a new unit. The new ISR4321 is running IOS-XE 3.16.2S and with the exact same config on it has been...
Thanks Elliott, I did already call Cisco today but TAC would not help without a service contract. Because I feel also that this is a bug I do not want to spend the $300 odd dollars for a contact only for TAC then to turn around and tell me its a bug ...
Thanks for the response, the reason the route is set as 254 is because that is the IP Address of the VLAN Interface on the core switch, 10.0.10.254 Cisco SG300-28P which does all the inter-VLAN routing.
Changing it to 252 would send it to the 2811 s...
