Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 5508 series WLC running 8.0.135.0. I have noticed that the rogue APs do not show up in the GUI until you run #show rogue ap sum in the CLI. Then again to get an update you must run the CLI command.
Has anyone noticed this?
I have a 5508 series WLC running 8.0.135.0. I have noticed that the rogue APs do not show up in the GUI until you run #show rogue ap sum in the CLI. Then again to get an update you must run the CLI command.
Has anyone noticed this?
I have two 5508 WLC v7.0. Two locations. Assigning Primary and secondary controllers to the APs how long would a client be "down" if a controller failed (assuming all APs are on one WLC) Would the type of wireless security be a consideration for spe...
I have a Cisco 5508 V7.0 with 1242 AP's. Two locations one controller LAG turned on. Vlan 2 exists at both locations with different networks behind it. i.e. Vlan 2 in Building 1 is 10.40.2.x and Vlan 2 in Building 3 is 10.40.141.x.On the 5508 contro...
In digging I found this statement,"WLANs may be configured to drop all client data locally at the H-REAP's wired interface (known as local switching). Locally switched WLANs may optionally carry 802.1Q tagging to allow such WLANs to be segmented over...
So if a controller fails there is a 5-15 second period of time the cleints will be "down" then the new controller takes over. I have been told 5-15 min.With HREAP will the clients, while the controllers are swapping, be able to access outside traffic...
Thats perfect, this was the issue we were having, the server is telling us it has 127.0.0.1 IP, the second server seemed to accept the IP fine, so we figured we messed up the initial config. I will download and try. thx
It is 1113, i noticed you had 4.1.1.24 as the 1113 recovery. Is this correct? There are three files for the 1113 running 4.1.1.23 when i looked.Can we just get the 4.1.1.24 and run it as the recovery? My guess is we would need to upgrade first.ACSse-...
