Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The UC500 has been setup with Configuration Assistant and all works fine including SIP Trunks and Unity.Inbound calls received on the FXO Port ring on the target phone but going off hook does not connect the call. The phone continues to ring.Any idea...
If all nodes are using private addressing for the LAN and some spokes have dynamically assigned Public addresses. What is the best IPSEC approach for these spokes to communicate with the hub for routing?
Thanks for your reply. I have actually managed to identify the problem.Finally I decided to test the cables which went through several connections.Using a POT I traced back for dial tone and found that I needed to replace one of the cables in the lin...
