Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I've got a 7200 vxr that I'm trying to create a named extended access-list in.I got to conf tif I go into ip after that the only commands available for access-list are log-update, logging, and resequence.so if I go back to the main config menu ...
Hello everyone, Just wanted to finish this up. You were right Giuseppe, it wasn't loading the actual IOS image into it.The router was a spare of someone else in the company given to me to use and they grabbed one that had no image on it.I've got ...
Okay, I just reset it to defaults, here is the full show version:Router(boot)#show versionCisco Internetwork Operating System SoftwareIOS (tm) 7200 Software (C7200-KBOOT-M), Version 12.3(6), RELEASE SOFTWARE (fc3)Copyright (c) 1986-2004 by cisco Syst...
Sure here is the command you listed above:OMEGA-edge(boot)#conf tEnter configuration commands, one per line. End with CNTL/Z.OMEGA-edge(boot)(config)#ip access-list ? log-update Control access list log updates logging Control access list logg...
Sure, here it is:Cisco Internetwork Operating System SoftwareIOS (tm) 7200 Software (C7200-KBOOT-M), Version 12.3(6), RELEASE SOFTWARE (fc3)Thank you for your valuable time,Allen
