Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here's the basic layout. Both cisco switches are flapping on ports 23 and 25 which are trunks. The MAC's exist on the 'right' side only. No router on the network, layer 2 only. Am I missing something simple?
Hey all, I seem to be having a 'dumb' moment. A colleague configured a 2960X and didn't setup SSH on it. I thought I did all the necessary steps, but I seem to be getting a login prompt I can't get past. Building configuration...Current configuratio...
This was it. I adjusted the priority manually, and the flapping stopped! Not sure how that changed, or why... bu that was absolutely the fix. Thanks, @MHM Cisco World!
Sorry, I've been changing things to try and get this working. I set the camera network to VLAN 250, and the FOSSIL network to 150, and set native VLAN to 1. I'm going to pull some new info from both switches, but I can't communicate with the switche...
WAT-A00-CCTV-NCF1(config-if)#do show spanning-treeOct 13 14:29:13.196: %SW_MATM-4-MACFLAP_NOTIF: Host 68d7.9a69.1a97 in vlan 250 i s flapping between port Gi1/0/23 and port Gi1/0/25int gi1/0/25 detailPort 25 (GigabitEthernet1/0/25) of VLAN0001 is des...
