Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So I have two ASR routers that I need to connect to two HA paired ASA's, routed mode. The ASA and ASRs are running EIGRP to pass routing info between them. A trunked interface on the ASA is connected to an ASR router interface, so it's L3 over L2. ...
I have an ASR 1001-X and have purchased two FLSA1-BIN-1X10GE licenses to enable the two 10G ports on the router. The ios version running is:
Cisco IOS XE Software, Version 03.13.02.S - Extended Support Release
Cisco IOS Software, ASR1000 Softwar...
I've read the post from 3 years past regarding this subject and the consensus was you must reboot the entire switch stack to upgrade ios, and this was ok because device connectivity is lost anyway even if you rebooted the switches individually.
Howev...
On an ASA 5520 ver 8.0(4) I have the following NAT senario:From my private interface "b2b-bastion" I want the following translation to occur when a packet goes from interface b2b-bastion to the external interface "b2b-dmz" and returns:b2b-bastion (pa...
I currently have an ASA5520 as my firewall and a 3005 VPN Concentrator in front of the firewall terminating VPN tunnels with a public peer address of say 1.2.3.4. The ASA 5520 also has a public IP address (say 1.2.3.6) in the same subnet as the publ...
I used the following commands to copy the files from my usb drive plugged into a leaf/nexus switch in ACI mode.Basically, you have to get to the usb directory and copy out of it to the bootflash directory. Didn't have to reformat my usb drive or reb...
Thank you for your reply!
I looked at the link and it has added to my confusion to the licenses. Here's another way of putting my question which I saw on another unanswered post:
If we buy 2 * FLSA1-BIN-1X10GE licenses for the Cisco ASR 1001-X , t...
Looks like I found the answer on page 2 of the following link:
https://www.cisco.com/c/en/us/td/docs/routers/asr1000/install/guide/1001-x/asr1hig-book/router_license_verify.pdf
It DOES require a reboot to activate the new 10G throughput level.
St...
I figured out a way to upgrade the IOS on a 3850 stack while minimizing down time--assuming Etherchannels are being used between 3850's in a stack for device HA--doesn't apply if attached devices are not Etherchanneled, then they will be down entire ...
