Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm attempting to form an EIGRP neighborship between two routers using VTIs. I'm able to establish the tunnels and can ping the VTI destination IP addresses on both sides with the size up to 1446 and DF bit set. When I add the EIGRP statements, I can...
Hello,We utilize FMC running 7.2.5 to manage, among others, a pair of FTD 2110s running 7.2.5 in active/standby mode. In the process of moving to 7.2.5 we also upgraded from SNORT 2 to SNORT 3.We have been getting reports, and have been able to repro...
I am troubleshooting a failed site-to-site IPsec tunnel between a Cisco ASA and a Cisco 8200L router. In comparing the IKEv2 properties I noticed that on the ASA it shows a pre-shared-key configured on the crypto map entry as well as on the tunnel-gr...
@balaji.bandi The three working routers are all older routers running IOS 15.6. The Hub or "Side B" router, and the "Side A" router are both running IOS-XE 17.5.1a.
@Rob Ingram that did the trick. I rebuilt the tunnel completely on the router and removed the pre-shared-key from the crypto map which allowed the tunnel to come up. Thank you!
