Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have installed 4 x 1542i Cisco AP's, set to use Mobility Express (v 8-10-130-0 ) in mode Bridge. They are two separate links operating independently to different buildings in the area.My issue is if both links are switched on the first link is dro...
Just to confirm for anyone following this. I did wipe the second ME unit and set back to CAPWAP, whitelisted it on the remaining ME controller and everything worked so will close this case.I still believe there is an issue on the ME code, why offer "...
I did try as the master and the other as the backup, no joy. I think its because its different programming, if it were the same it would keep an image of the master and kick in when needed.
Hi, thanks for the info on the Firmware. I suspected layer 2 and the 2 x ME boxes talking to each other, after 2 months I have been advised not to run 2 x Controllers. I am looking to convert one back to CAPWAP and set as the RAP on the 2nd bridge an...
Site have enabled both links, only one works, nothing trapped with STP on the switches so this is not a loop. I have always suspected Cisco firmware to be the issue but this is not being honoured under warranty even though we have put our case throug...
