Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
A question about VRRP instances/groups and a request for suggestions from the Community.Equipment: Cisco 7609, Cisco NCS-55A2, Cisco Nexus 5596Is VRRP limited to 255 instances? Is there a difference between a VRRP instance and a VRRP group?If there a...
We have a retail store that is directly connected to our network via fiber, thus we have the AutoVPN disabled (as it is not needed).The store is coming into our gateway (Cisco ASA) on VLAN 100.The store is using an MX85 with SFP on WAN1 to connect di...
You are correct and I have been schooled. Did not realize the NAT was taking place. I had never assigned a static IP to a device on the inside of the MX for testing.
There is no need to use the AutoVPN. The retail store's network is coming in direct and the VLAN terminates on the ASA. There is no NAT being performed. So, in this scenario DHCP relay is not possible? The route exists (through the primary "WAN" lin...
The MX is the edge router for this remote site, but it is directly connected to the primary network. There is no NAT being performed. A capture on the ASA interface shows ICMPs from the MX Toolset for Internet (10.100.1.1) and VLAN 5 (10.10.10.1).
We could use the MX DHCP server, however we have many other retail sites that use MXs and the AutoVPN connected to a central DHCP server. We would like to keep everything together. -- I have read the article that you posted before. We are not utili...