Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've just bought a 2nd user AP-350 but can't reset it. I have found its IP address using CDP from a connected switch. When i browse or telnet to it i'm prompted for a username & password. This is the same for any console access.I have followed instru...
It transpires I had to:"Reset for Boot-block Versions 1.02 and Later"This procedure was found in a doccument here:http://www.cisco.com/warp/public/102/wlan/pwrec-2.html#- also, word is that the hammer method works too :O)sean
