Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a ASA 5520 that I have configured with an ASA -SSM10 card, I have it setup to scan traffic in my lab, is there any site I can use to test that the IPS is actually working?
I have a site that has a single MPLS link to it,I have an ASA firewall out there connected to a DSL internet connection. My question is where can I find a good guide to help me configure routing my router or switch to use the ASA VPN tunnel back to ...
I have just setup a 6513 with a firewall module running 2.3(4) software. I have configured the Vlans and put them in the Firewall Vlan group. I assigned the IP's on the firewall.What I do not understand is thisI have a DMZ that is VLAN 600On the 651...
Thanks for the document, so say my remote location is 10.97.x.x and the 10.97.x.x is going over the vpn tunnel to my central data center, how will my core switch know not to send the 10.97.x.x out over the MPLS cloud, but back to the VPN tunnel.
Thanks Saju, that part at the remote site I understand thanks to your help, but what I need to figure next is in my Datacenter what would I need to do to make sure subnet that comes in over the VPN tunnel goes back out the tunnel and not over the WAN...
