I normally use the "sh environment all" command to find that info (I believe that is included in the output of the sh tech as well but you have to sort through everything to find it):U03751301#sh env allArbiter type 1, backplane type 7513 (id 2)Power...
Basically, the loopback interface is a virtual interface that you configure on the router. Being a virtual interface, it never goes down unlike physical interfaces so as long as you have one physical interface reachable on your router, you should be...
We tested with no issues by shutting down both the LAN interface on the router where VRRP is running, shutting down the serial interface that is being tracked, and by powering off the router. We are tracking the line protocol in VRRP, but there are ...
I've never seen it used to send messages to a syslog server, I've only seen it used to send snmp alerts to a network management station. What exactly are you trying to do, send a syslog message back to your server everytime a change is made?
When you say you don't see LMI on the corp side, I assume you are sending LMI out from the router but are not receiving from the frame switch?If LMI is not passing back and forth between the router and the frame switch you can isolate the problem to ...